MVP Development Tasks¶

Monitor¶

Note: Touch Display is already supported

Hardware¶

• Pair Button support (GPIO pin)
  • Needs to include LED so we know we're in that mode
• 2G/3G support based on Raspberry Pi phone build
  • https://www.graphics-muse.org/wp/?p=5910
  • Not absolutely required - only used as backup if Internet connection goes down.
• Requires Backup Battery Circuit board
  • This will handle power input from AC (wall socket) or battery. Battery should only be backup power!
  • http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Battery Backup section)
  • Needs to set GPIO pin that can be read at boot.
  • Needs LED that can be enabled from boot process (not connected to Pair Button) via GPIO to show we're in Pair Mode
• Requires PiDrive for external storage
  • http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Monitor section)
• Needs WiFi + BLE HAT
  • http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Monitor Section)
• Needs Enclosure
  • PiDrive access door
  • Battery access door
  • SD card access
  • open USB ports access
  • Display on top
  • LEDs visible

Software¶

• Pair Button support on boot
• Write to work like ESP8266 where boot mode can set up AP to allow configuration via mobile device
  

      Handles both Internet wifi setup and sensor network AP config.
      if (pair_button)
      {   
          enable ap only
          enable wifi config in web server
      }
      else
      {   
          enable ap
          enable internet wifi connection
          disable wifi config in web server
      }
  

• New launcher supporting UI design.
• piboxd updates
  • needs to support sensor messages (store to sensor location). overwrite with latest message in per-sensor file.
• Battery backup
  • On AC power failure, send notifications and continue running.
  • power down safely (signal all apps) when battery is low.
• Install
  • must format hard drive on firstboot
    • partition 1: app data
    • partition 2: camera recordings
• New apps:
  • Sensor config/browse
  • Contacts (for notifications)
  • Files (for cleanup, status viewing)
  • Setup (admin pw, generate keys for sensors)

Sensors¶

Fork esp8266 project

Hardware¶

• Add pair button + LED
• Add battery power w/ enclosure
• Add door/window sensor
  • http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Door/Window Alarm section)
• Needs enclosure
  • Battery access
  • Pair button access
  • LEDs visible

Software:

• Rework esp8266 code to handle new flow diagram.
• If necessary, simplify REST interface.
• Add AES encoding + hash for all messages (inbound and outbound from sensor).

Management¶

• Android:
  • Wifi config
    • connect to AP (monitor or sensor)
    • configure network
    • Set admin pw (part of initial setup)
  • View sensor status
  • Admin
    • Set admin pw (via sensor network only)

• Web UI:
  • View sensor status
  • Admin
    • Set admin pw
    • gen keys
  • Files
    • List
    • Delete
  • Wifi config
    • Only available if in Pair mode