MVP Development Tasks » History » Revision 4
Revision 3 (Hammel, 13 Jul 2017 15:31) → Revision 4/7 (Hammel, 13 Jul 2017 15:32)
h1. MVP Development Tasks
h1. +Monitor+
Note: Touch Display is already supported
h2. Hardware
* Pair Button support (GPIO pin)
** Needs to include LED so we know we're in that mode
* 2G/3G support based on Raspberry Pi phone build
** https://www.graphics-muse.org/wp/?p=5910
** Not absolutely required - only used as backup if Internet connection goes down.
* Requires Backup Battery Circuit board
** This will handle power input from AC (wall socket) or battery. Battery should only be backup power!
** http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Battery Backup section)
** Needs to set GPIO pin that can be read at boot.
** Needs LED that can be enabled from boot process (not connected to Pair Button) via GPIO to show we're in Pair Mode
* Requires PiDrive for external storage
** http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Monitor section)
* Needs WiFi + BLE HAT
** http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Monitor Section)
* Needs Enclosure
** PiDrive access door
** Battery access door
** SD card access
** open USB ports access
** Display on top
** LEDs visible
h2. Software
* Pair Button support on boot
* Write to work like ESP8266 where boot mode can set up AP to allow configuration via mobile device
<pre>
Handles both Internet wifi setup and sensor network AP config.
if (pair_button)
{
enable ap only
enable wifi config in web server
}
else
{
enable ap
enable internet wifi connection
disable wifi config in web server
}
</pre>
* New launcher supporting UI design.
* piboxd updates
** needs to support sensor messages (store to sensor location). overwrite with latest message in per-sensor file.
* Battery backup
** On AC power failure, send notifications and continue running.
** power down safely (signal all apps) when battery is low.
* Install
** must format hard drive on firstboot
*** partition 1: app data
*** partition 2: camera recordings
* New apps:
** Sensor config/browse
** Contacts (for notifications)
** Files (for cleanup, status viewing)
** Setup (admin pw, generate keys for sensors)
h1. +Sensors+
Fork "esp8266 project":https://gitlab.com/xarduino/iotdevice
h2. Hardware
* Add pair button + LED
* Add battery power w/ enclosure
* Add door/window sensor
** http://redmine.graphics-muse.org/projects/ironman/wiki/Hardware_Links (Door/Window Alarm section)
* Needs enclosure
** Battery access
** Pair button access
** LEDs visible
Software:
* Rework esp8266 code to handle new flow diagram.
* If necessary, simplify REST interface.
* Add AES encoding + hash for all messages (inbound and outbound from sensor).
h1. +Management+
* Android:
** Wifi config
*** connect to AP (monitor or sensor)
*** configure network
*** Set admin pw (part of initial setup)
** View sensor status
** Admin
*** Set admin pw (via sensor network only)
* Web UI:
** View sensor status
** Admin
*** Set admin pw
*** gen keys
** Files
*** List
*** Delete