Feature #385
closed
Build power on/off support HW for Media Player
100%
Description
The design has been diagramed and there are off the shelf parts for this so now I need to order them, prototype the design and integrate with the custom media player case that is under development.
Here is the design as it stands now.
Files
| PiBoxMediaPlayerCase.dia (3.99 KB) PiBoxMediaPlayerCase.dia | Dia diagram for Media Player case and hardware | ||
| PiBoxMediaPlayerCase.png (27.9 KB) PiBoxMediaPlayerCase.png | Image of the design | ||
| PiBoxMediaPlayerCase.png (35.9 KB) PiBoxMediaPlayerCase.png | Updated to show dimensions of major components. |
Related issues
Updated by Hammel about 10 years ago
- File PiBoxMediaPlayerCase.png PiBoxMediaPlayerCase.png added
- Status changed from New to In Progress
- % Done changed from 0 to 10
Updated the diagram to show sizes in mm (easier to work with in Blender) for everything except the SPST switch, which I haven't chosen yet. I also need to create a repo to hold the diagram too.
Updated by Hammel almost 10 years ago
- Target version changed from 0.10.0 to 0.11.0
Updated by Hammel almost 10 years ago
- Severity changed from 03 - Medium to 04 - Low
Updated by Hammel over 9 years ago
- % Done changed from 10 to 70
The prototype cases were built out of wood boxes I purchased from Michael's (pictures coming). The power on/off support is handled with a SPDT switch that is tied directly to the power input on two different devices for both the Media Server and Media Player.
In the Media Server the UUGear 7-port hub was unable to power the RPi, so I tied the SPDT directly to the power input on both boards (the UUGear is jumpered to be self-powered only). Ground is common to both devices and the input power (a 5V/4A barrel connected wall-wart).
In the Media Player the SPDT power is tied to the power input on the RPi. The power input comes from a micro USB 5V/2A wall wart that is tied directly to the pico projector. In this way, whenever power is plugged into this box it will try to charge the projector, but will only power the RPi when the SPDT is switched on.
In both cases it's important to have enough amps in the wall-wart/power source or the circuit fails to boot the RPi.
It's a really simple circuit in both cases, using off-the-shelf breakout boards from Sparkfun.
Note that the LiPo power in these prototype cases is just an externally connected Jackery Giant battery pack. But a wall-wart works as well.
Updated by Hammel over 9 years ago
- Status changed from In Progress to Closed
- % Done changed from 70 to 100
I added a power switch to the prototype cases that works fine. The design will be integrated into the 3D models. This issue can be closed.