Actions
Documentation #676
open
Verify breadboard designs in Fritzing are up to date
Start date:
16 Sep 2018
Due date:
% Done:
20%
Estimated time:
Severity:
05 - Very Low
Description
Verify these designs match the implementation.
- The ESP-01 programmer
- The ESP-01 light switch
Then clean up the schematic and PCB layouts. These should match the current prototype.
Then replace- FTDI Basic with a header
- Keyes Relay with physical components, see
- YwRobot Power Supply with physical components, see
The PCB should be breadboard friendly so it can support a YwRobot.
There should also be an option of having the PCB standalone, with a YwRobot header.
There should also be an option of having the PCB standalone, with the YwRobot built into the PCB.
Related issues
Updated by Hammel almost 6 years ago
- Severity changed from 05 - Very Low to 01 - Critical
Updated by Hammel almost 6 years ago
- Status changed from New to In Progress
- % Done changed from 0 to 20
I've reworked the imlightsw design to remove the YwRobot power supply and replace it with a mains connection (via a 110v to 5v converter) and connection points for both the relay board and the FTDI Basic board.
I sent the design to OSH Park for review. They'll get back to me later this week or next.
Updated by Hammel over 4 years ago
- Severity changed from 01 - Critical to 05 - Very Low
Actions